center to center of the bar ends if i remember correctly

 

Thanks...and which end does the super pivot go onto? I have it on the axle currently but it is loose as hell has play back and forth

 

axle side for the lower bars, is correct for the super pivots.
yes starting point for the lower bars is 15.5 center to center. (for the orginal version of the 3/5 link) new version is 17" if i remember correctly?
then move in or out to adjust pinion angle.

 

as mentioned 15.5" for the older version, but you can move the gastank x-member towards the axle 1/2" and set the bars to 16" to somewhat make up the difference between old n new style

 

when did they change to the "new version" ?

 

within the last couple months idk when for sure, just know that mine was old style bc i got it used

 

Arg... I have the new style and cant find the right measurements. Im also thinking this is the reason that I have to put washer in where the super pivots are.:doh:

 

new bars are 17 ish... just align them were the lowers are even, not everybodys going to be the same just make sure your pinion is alright

 

6 3/4" is the measurement i think for moving the spring perch, i just forget which holes to align n such, then bc the wishbone is longer, you set the lowers 17" c to c and all the other important shit

 

17 7/16" i think is what my bars say on them. im sittin at work right now so i cant check them to make sure, but i'll check them when i get home and will get back to you.

 

17 5/16"