Conyers GA.
Got a project that I have decided to finally move. Not looking like i'm going to be able to obtain the motivation that is needed to finish it.
2003 ZQ8 S10
-Was a 4.3 v6 5 speed truck. No engine or trans now
-Traditional body drop. setup for no AC
-tubbed for 20's possibly 22's upfront.
-cab moved back 3/4 inch.
-front frame horns have been dropped 2.75-3 inches for the BD. not finished out though.
-triangulated 4 link out back, bag on bar. has shocks in rear. no stock gas tank, has fuel cell
I have some fenders, a hood, a grille and headlights, core support, front bumper, and wiring for it. No bed, No drive train like stated above. I'm pretty sure i have some power doors for it. I know i at least have one.
As of right now, it does not have control arms on it, but i do have some that could be put on for the right buyer. It has stock spindles, no tie rod notch.
The master cyl was designed to sit at the top of the tub angled upward to clear a 255/35/20 but could use a little metal work to look a little better. it is sturdy enough to use though.
It does not have the wheels in the pic. It would be sold on stock 98 blazer swirl wheels.
As of now i am accepting offers.
project thread here
http://www.s10forum.com/forum/f30/project-2003-zq8-zebra-488797/
Got a project that I have decided to finally move. Not looking like i'm going to be able to obtain the motivation that is needed to finish it.
2003 ZQ8 S10
-Was a 4.3 v6 5 speed truck. No engine or trans now
-Traditional body drop. setup for no AC
-tubbed for 20's possibly 22's upfront.
-cab moved back 3/4 inch.
-front frame horns have been dropped 2.75-3 inches for the BD. not finished out though.
-triangulated 4 link out back, bag on bar. has shocks in rear. no stock gas tank, has fuel cell
I have some fenders, a hood, a grille and headlights, core support, front bumper, and wiring for it. No bed, No drive train like stated above. I'm pretty sure i have some power doors for it. I know i at least have one.
As of right now, it does not have control arms on it, but i do have some that could be put on for the right buyer. It has stock spindles, no tie rod notch.
The master cyl was designed to sit at the top of the tub angled upward to clear a 255/35/20 but could use a little metal work to look a little better. it is sturdy enough to use though.
It does not have the wheels in the pic. It would be sold on stock 98 blazer swirl wheels.
As of now i am accepting offers.
project thread here
http://www.s10forum.com/forum/f30/project-2003-zq8-zebra-488797/
