S-10 Forum banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Anyone have the 2.5” on a zr2 and run into some bad tie rod end angles by bareley turning up the keys? I just installed mine and had the bolts turned maybe 3 rotations and my tie rod angles went to **** but the bj angles were fine, is this just an issue an alignment will solve or no?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.