S-10 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
98 Posts
Discussion Starter #1
Hello all, I’m switching my stepside bed to a fleetside bed and I have ordered every Xtreme part needed for the bed except the right rear bed skirt.

I am wondering If on here that has the right rear bed skirt, are you able to take it off and get it scanned for 3d printing? I would pay for this...

Thanks


Sent from my iPhone using Tapatalk
 

·
time to get cereal
Joined
·
2,277 Posts
I would definitely keep looking. In my experience, 3D printed stuff would not hold up to being mounted to the exterior of a vehicle, especially what is basically the underside of it.
 
1 - 5 of 5 Posts
Top