S-10 Forum banner

1 - 2 of 2 Posts

·
Saweeeeeeet
Joined
·
224 Posts
Discussion Starter #1
Ok here it is. threw down some money for LEDs for my truck 97. Ok installed the LEDs in the back all 3 in each tail light Parking #194 the brak/turnsignal 3150 and the back up bulb 3057. Ok they all work great on braking, parking lights, and turn signals. So I move to the fron of the truck. install the parking/turn 194 in the lense and then the big parking/turn signal 3157 in the front bumber. Ok All light will turn on and brake lights will work. and then I go to click on the turn signals and all I get it a little dim green arrow and stays on. Turnsignals on the outside don't work.
With lights off and push the hazerd in they flash but if I put on the head lights they don't. I did go and buy better flasher relays at auto zone so they aren't the factory and now I have not clue what the hell is going on ANY HELP PLEASE:rock:
 

·
Registered
Joined
·
1 Posts
HI, try to put a light bulb in serie and see what happens.
The relay often need to feel a load to work.if it works you can buy a resistor an put it in serie with the ligt,then it should work.

Patrik.
 
1 - 2 of 2 Posts
Top