S-10 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey i got a 98 s10 with a V8 swap which has a 4 speed muncie and a 10.5 inch napa clutch. I had a centerforce clutch in it but i destroyed it with only 500 miles on it. I have a howe's throwout bearing in it now just trying to figure out what everyone else might be using for a slave cylinder set up. I was thinking about a six speed swap just wondering about the tremec or what might be a better fit for this set up. Any ides would be helpful. This truck also makes about 400hp and 450 torque.
 

·
Gears and Differentials
Joined
·
1,395 Posts
I have a CF II in my S10 with a 3.4 and a CF DF in my Camaro with a 427 and they both have worked very well for many years and a lot of abuse.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top