S-10 Forum banner
Status
Not open for further replies.

Using the framerails as exhaust tubing on a SFBD

8K views 36 replies 20 participants last post by  Rhotpursuit 
I'm fully aware this is an old thread. With that said, how do you think I arrived here? I can tell you, because it was the 4th site listed for a Google search for "using framerails for exhaust".
That being the 4th search attempt wording that finally got me a discussion on topic.
Oval exhaust tubing ceramic coated and heat wrapped. If you only wrap the parts that get hot, how is it possible to have "wet heat wrap"? Anyone that has used heat wrap knows it dries very quickly if it gets wet while running. Condensation inside the exhaust pipe comes out as white smoke in the form of water vapor from a cold start. It vaporizes from heat wrap in the same fashion. It will also greatly reduce condensation in the exhaust pipe because it's insulated. This is the answer anyone searching those terms is probably seeking. It took research, discussion, and practice to formulate the solution. I would have been ecstatic if it was here when I was searching, so I'm paying it forward.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top