S-10 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hi,
I've noticed that the driver's side front bumper assembly on most '96 s-10 blazers seems to droop down a little, leaving a larger gap between the bumper and the headlight bezel on the drivers' side.

Could someone recommend a procedure for evening this out.
Thanks,
Joe.
 

·
T/A drivin foundin member
Joined
·
538 Posts
Step one: get a hi-lift jack

step two: put it under the bumper

step three: crank away until bumper is at desired heigth

step 4: remove jack

happy cruisn!
 
1 - 2 of 2 Posts
Top