S-10 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
129 Posts
Discussion Starter · #1 ·
gotta do the spindles myself, in the parking lot of my apartment complex...idiots down here at the only place I could think that might be able to, said they could do it for 300...about loaded my pants...so I figure I can tear it apart as well as anyone...any pointers or instructions?
 

·
Registered
Joined
·
129 Posts
Discussion Starter · #3 ·
ok tell me if I am wrong this is how I was thinking....I would jack up the truck put it on a jack stand and use my floor jack top support the lower control arm....then I was going to take off the tie rod end and brake caliper.....then undo the castle nut ont he top ball joint and thte same for hte lower....now will the ball joints stay in the control arms....or ar ehtey pressed into the spindle?
I was thinking it would be wasy to pull out and put in....no hamering....or having to press anything.....I could be wrong since I have never done it....looked in truckin and they did it to a full size truck...looked easy to pull out....
 
1 - 2 of 2 Posts
Top