Tools needed are a 3\/8" socket driver and a deep wall 15mm socket, and a #2 phillips head screwdriver..\n\nTotal nuts unbolted amount to 8-15mm \nTotal #2 phillips head screws amount to 2 \n\nPic's displayed are shown in order on how to take seats out.\nTotal time a beginer 30min.\nTotal time a pro. 10min. or less.\n\nNow when u have the seats unbolted, lift up over the ends of the bolts mounted in the floor and be carefull not to hit the trim,dash,and most importaint the body. \n\nWhen re installing seats, place seats back in over the floor mounted bolts and bolt back down. Be carefull not to over tighten the nuts or u will strip the threads. \n\nTotal time a beginer 30min.\nTotal time a pro. 10min. or less.\n\nA helpfull hint...\nAfter the seats have been taken out do not re adjust the position of the seat, or u will have trouble remounting them.