S-10 Forum banner

So. Cal - 2 sets of black steelies 15" fs/ft

2076 Views 14 Replies 4 Participants Last post by  dnyce
4
I have 2 sets of black steel wheels for sale/trade. They are 15". I'm not sure what brand these are, but the wheels with the red/blue stripe I believe have a backspacing of 4" and the all black have a 3.75" bs.

In the quest to fix a vibration in the rear of my truck, I went through these 2 sets of wheels thinking I had a bent wheel, but it turned out to be a bent axle shaft, so now i have these to sell.

I will accept a trade for a set of axle shafts from a 98-03 2wd blazer with disc brakes as long as they are not bent. We each pay our own shipping, straight across trade.

Looking for $80 each set ($20 per wheel). I have 2 sets of center caps too. The wheels have a little bit of paint chipping on the lip from where wheel weights were, but are in overall good condition, but are dirty from being outside. The center caps are OK, but some have a couple dings in them. I prefer local sales, but will ship.







See less See more
1 - 9 of 15 Posts
yeah, i'll grab a quote tomorrow when I can weigh them.
So its a ridiculous amount to ship these apparently. USPS was the cheapest at $31 a wheel. :eek:

At that rate you'd be better off buying a set of black summit wheels with free shipping for $180-$200.

http://www.summitracing.com/parts/sum-85-5861/overview/

http://www.summitracing.com/parts/sum-84-5861/overview/
wheels with blue/red stripe are sold!
Both sets sold. Thanks!
4
Sale fell through on the all black wheels, so they are still available. These are local pick up only! Shipping costs as much as the wheels themselves, so there is no point.

Also have a practically new set of 31x10.50r15LT load C Nexen Roadian HT tires with 1000 miles on them. $400 firm (Paid $550). Also local pickup only, please!

Located in Santa Ana, CA







See less See more
lol, i'll keep that in mind! I'd be paying you to take them at UPS's rates haha.
Good question. They are 3.75" backspacing. I'll have to do some reading to see.

How are those ART arms workin' out? I saw you had a busted lower ball joint in your build thread, was that on the ART's?
Did some searching and I don't think these are going to fit that well. They are -19mm offset and that may stick out too far.
1 - 9 of 15 Posts
Top