S-10 Forum banner
1 - 15 of 15 Posts

· .
Joined
·
3,776 Posts
Discussion Starter · #1 ·
I have 2 sets of black steel wheels for sale/trade. They are 15". I'm not sure what brand these are, but the wheels with the red/blue stripe I believe have a backspacing of 4" and the all black have a 3.75" bs.

In the quest to fix a vibration in the rear of my truck, I went through these 2 sets of wheels thinking I had a bent wheel, but it turned out to be a bent axle shaft, so now i have these to sell.

I will accept a trade for a set of axle shafts from a 98-03 2wd blazer with disc brakes as long as they are not bent. We each pay our own shipping, straight across trade.

Looking for $80 each set ($20 per wheel). I have 2 sets of center caps too. The wheels have a little bit of paint chipping on the lip from where wheel weights were, but are in overall good condition, but are dirty from being outside. The center caps are OK, but some have a couple dings in them. I prefer local sales, but will ship.







 

· .
Joined
·
3,776 Posts
Discussion Starter · #3 ·
yeah, i'll grab a quote tomorrow when I can weigh them.
 

· .
Joined
·
3,776 Posts
Discussion Starter · #5 ·

· .
Joined
·
3,776 Posts
Discussion Starter · #6 ·
wheels with blue/red stripe are sold!
 

· .
Joined
·
3,776 Posts
Discussion Starter · #7 ·
Both sets sold. Thanks!
 

· .
Joined
·
3,776 Posts
Discussion Starter · #8 ·
Sale fell through on the all black wheels, so they are still available. These are local pick up only! Shipping costs as much as the wheels themselves, so there is no point.

Also have a practically new set of 31x10.50r15LT load C Nexen Roadian HT tires with 1000 miles on them. $400 firm (Paid $550). Also local pickup only, please!

Located in Santa Ana, CA







 

· .
Joined
·
3,776 Posts
Discussion Starter · #10 ·
lol, i'll keep that in mind! I'd be paying you to take them at UPS's rates haha.
 

· .
Joined
·
3,776 Posts
Discussion Starter · #12 ·
Good question. They are 3.75" backspacing. I'll have to do some reading to see.

How are those ART arms workin' out? I saw you had a busted lower ball joint in your build thread, was that on the ART's?
 

· Registered
Joined
·
2,525 Posts
Na not the arts's, my stock ones broke. Those art arms are going on much sooner than I wanted now tho lol-I want to sell the 20"s off my truck to fund more parts, I never liked em. Might need some interim wheels
 

· .
Joined
·
3,776 Posts
Discussion Starter · #14 ·
Did some searching and I don't think these are going to fit that well. They are -19mm offset and that may stick out too far.
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top