S-10 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
385 Posts
Discussion Starter #1
Okay i have a 91 s10 regular cab that is bagged and it has mono leaf (flipped leafs) with belltech 3 inch blocks (not angled).
SO i have drive line vibrations and my drive shaft is out of the tranny a far bit. So should a buy the pinion shims?? What ones if so? or buy any angled blocks?
Can any one tell me how they got rid of drive shaft vibrations with a mono leaf setup?
thanks
 

·
Registered
Joined
·
13,733 Posts
Ditch the mono and do a proper setup. Thats how you get rid of the vibrations.

Flipping the leafs is worse than running a monoleaf in the first place. Get a used pair of leafs off a 94-97 dime, break the pack down to the longest and overload leafs, have it dearched, and use a 4" angled block, and that should solve your problems, as well as create a safer ride for you and everyone driving around you.
 

·
It Has Been Awakened
Joined
·
1,930 Posts
go with slammeddime. although, i had angled blocks on my truck before i bagged it, and at anything above 80mph i got the u-joint vibration problem, and my truck was hard on u-joints, so i really dont think the angle did its job, so i would save shim it till you get the pinion correct with the blocks.
 
1 - 3 of 3 Posts
Top