S-10 Forum banner
1 - 3 of 3 Posts

·
fallen angel
Joined
·
156 Posts
Discussion Starter · #1 ·
recently i dropped my 95 s10 3/4 but the only bad thing is that i also replaced the balljoints and when doing so they went in through the control arms fine but for some reason the don't go all the way through on the spindle and has a gap between the control arm and spindle of about and inch, the bolt at the bottom is on tight and has the pin passing through the balljoint and the ride is, i don't know if i bought the wrong ones they told me i shouldn't force them through so can anybody help me out here i really need to fix this problem

the drop kit is springs/shocks upfront, and blocks/shocks in back
 

·
Registered
Joined
·
105 Posts
upper ball joint or lower? the upper should be right because they bolt in, but maybe the lower one didnt get pressed all the way, did you use a ball joint puller?
 
1 - 3 of 3 Posts
Top