S-10 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter #1
I intend to remove a Sonoma, 6’, fleetside bed Saturday to facilitate rust treatment of the bed and frame. I very much want to stand the bed on end to facilitate working on it.

If I place some XPS (rigid) foam board over hard, flat ground, can the front, bottom corners of the bed support a fair amount of the beds weight while rolling/tipping it upright on the XPS, without damage?

Thank you.
 

·
B4U Task Force Admin
Joined
·
24,645 Posts
I just put a couple of towels dow to keep from scratching it. Worked fine.
 

·
Lifelong S-10 Owner
Joined
·
494 Posts
I've had a bed standing in the corner of my shop for over 14 years now. Stood it up on a moving blanket and set it on a pallet.
 
1 - 5 of 5 Posts
Top