S-10 Forum banner
1 - 2 of 2 Posts

·
Broke Mini-Trucker
Joined
·
140 Posts
Its not really that hard to do it yourself. Im not sure what kind of setup you have but they are all relativly simple. All you need is an inch pound torque wrench and a dial indicator. Unless you have to shim the pinion (like the ford 8 inch) then I would take it to the dealer.

If I were you I would get a book that lists the steps on how to set backlash and do it yourself to save you some $. You may want to replace the cruchable spacer (if you have one). You are only supposed to use it 1 or 2 times. Hope I helped. Good luck!
 

·
Broke Mini-Trucker
Joined
·
140 Posts
Im not too sure that they would carry a dial indicator or not, check out craftsman tools. You will most likely have to order one and they might run about 100 bucks or so for a good one. But thats still better than 65x4.. I just seen a post that you should checkout. It gives nice details and all the specs... go to the "s-series how to" board and find the zexel torsen install. He explains it in much better details than I can. Later man, Good luck
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top