S-10 Forum banner
1 - 4 of 4 Posts

423 Posts
Discussion Starter · #1 ·
So I printed the wiring chart from AVTekk's FAQ...and I'm looking at the pin harnesses on my remote start unit.

So far, the only thing that I am unsure about is the main power (constant 12v) feeds.

According to the FAQ, it only lists one red wire as the constant 12v. The remote start unit has TWO main power inputs on 2 seperate wires labeled Main Power input A and B. Do These both get spliced into that one red wire on my column?

In addition - there is a seperate harness on my remote start that asks for Main Power (+12v input). Does this THIRD wire get spliced into that one red wire on my column too?

This would be a total of 3 seperate wires spliced into 1 wire on my column providing a constant 12v. Is this correct? Is this safe?

Any input is appreciated, thanks.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.