S-10 Forum banner
261 - 280 of 312 Posts

· ELTC
Joined
·
8,281 Posts

· Registered
Joined
·
585 Posts
Discussion Starter · #264 ·
well last weekend marked 1 year since the completion of "The Bomb" as it's become. here's some pics from this past weekend, im thinking a little rework might be in the future for this dime what you guys think?

4 out of the 5 rides



 

· ELTC
Joined
·
8,281 Posts
your dash vents and speaker covers looks so much better than mine do. crazy road glare right!
 

· Registered
Joined
·
585 Posts
Discussion Starter · #269 ·
Well, the bomb has gone back under the knife, time for a little change up. have a little list of new things in store for her this includes;
- stock hood
- new electric fan setup w/ shroud
- inner fenders
- new wheels
- new stereo setup
- all new upholstery
- new webasto electric ragtop
- grant 88-98 bumper
- s10 grille / lights
- new kinetik batteries
- new paint
- freshen up engine
- redo all powdercoat on front and rear suspension
only 195 days to have it done ready set GO!!

Sold my 18/20 boyd coddington turbines to fellow redemption club member. these loaners will do for now until my new shoes show up....


ac / power steering bracket was just a bit too tall...


throttle body needed to be moved off the top of the motor to clear hood.


little more progress on TB relocator, hoping to finish it up tonight and test fire truck. hope all goes well. if not ill toss it and start over...
 

· Registered
Joined
·
585 Posts
Discussion Starter · #278 ·
@baggedsonoma22
after our talk at forbidden i began looking more seriously into it. just sort of went for it and took a little trial and error. i need to play with the throttle cable/pedal/bracket some more but was good enough to cruise cross town to the body shop with no problems. So im calling it a success for right now.
 

· Registered
Joined
·
585 Posts
Discussion Starter · #279 ·
well the countdown is getting much closer.... oh well 37 days and counting here's a couple pics. the truck is still at Kal Koncepts receiving the exterior makeover, while back at the shop im pre-fabbin what i can and just preparing for it's arrival. Some pics now for those of you that follow this thread.
cad drawing for links

cad drawing or the air management rack (for utility use and to supply tilt bed with air as well)

new lower links, i felt the existing ones just didn't flow with the look i wanted for the truck. If i have time a new wishbone will be added to better match the links also.



the last pic of the truck i have before "the magic happens"

a pic of the amps ill be running this time around
 
261 - 280 of 312 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top