S-10 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
Hi kids! I am new to this forum but an old hand at engine swaps & yet I am looking for some help with finding some 2.8 engine mounts. I have a 88 Xtra cab with a 88TBI 350 / 350 turbo installed twisting on a 77 lincoln disk brake 9" ford. Narrowed, of course! My Q. is ... where does one get some polyurethane motor mounts or some hard rubber motor mounts for this application ? They need to be for the 2.8 V6 as that is the system I have in place.
Also, if anyone has Q.s on doing a V-8 swap in a FWD, I did one in 89 to a 85 fwd befor all the trick mounts & stuff were out.
If you are doing the V-8 swap, don't hesitate to E. me with Q.s, I have found some (little things) that make life easier.:axe:
 

·
Registered
Joined
·
25 Posts
Discussion Starter #3
The JTR swap book gives a few options as in stuffing the Vette inner rubbers into the 2.8 shell but I don't really want to do all that crapp. Keep an eye on my thread & we'll see what comes up from the gang. :monkeypee G.W.Bush ha Ha!
 
1 - 4 of 4 Posts
Top