S-10 Forum banner
1 - 2 of 2 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
. I paid for and downloaded the ALDATA program and it has been no help. What I am building is a 1993 S10 and putting in a dash from a 1988 that was much better shape than the one that was in there. Also putting in a 350. Grafting the 88 dash to a 93 has been challenging. I did a 1991 S10 that I put a LT1 into that was much easier than this has been.
I need the bulkhead connector pin out and the one for the ignition switch. Any thing else you can help with would be greatly appreasheated.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.