S-10 Forum banner

1 - 13 of 13 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter #1 (Edited)
Hey guys I know I havent been around in like 3 months lol but... since I have been gone and have forgot all my the research I have done. I was wandering what in your OPINION is the best and cheepest way to lift a 99 4x4 about 3-4 inches? I am mainly concerned with money. I am fairly good at turning wrenches so making something custom is ok. I ma just looking for some ideas.

Main areas of concern:
1st: money
2nd: reliability
3rd: ease of manufacturing/install

I am just looking for opinions so any will be apreciated.
 

·
3 Leaf Fab
Joined
·
4,082 Posts
Hey guys I know I havent been around in like 3 months lol but... since I have been gone and have forgot all my the research I have done. I was wandering what in your OPINION is the best and cheepest way to lift a 99 4x4 about 3-4 inches? I am mainly concerned with money. I am fairly good at turning wrenches so making something custom is ok. I ma just looking for some ideas.

Main areas of concern:
1st: money
2nd: reliability
3rd: ease of manufacturing/install

I am just looking for opinions so any will be apreciated.
sfa swap. it can be cheap, if you know what you are doing. it can certainly be more reliable, and can be simple if once again, you know what you are doing. all based on fabrication experience, etc.
 
1 - 13 of 13 Posts
Top