[wayne c]

well this is kinda of silly but here goes.I'm putting hydros on my 96 Sanoma i have just the front and i was wondering how the hell do i get a hole saw in their to cut the frame when their is no room? I installed hydros in my 86 cutless years and years ago but that was easy compained to all the crap on my truck. If you need to know it has a 2.2 and manual tranny.This whole truck build is going to be alot of old school stuff with a few modern up to date stuff just ready to get hopping so to speak. Can i do away with the anti lock crap? what would i have to do?

 

[1lowryd]

to be honest i got fed up with the hole saw n used the torch but u could prob use a cut off wheel just the same.

 

[1lowryd]

or try to hole saw it from above like through the engine compartment down to the ground

 

[AndrewH]

Are you trying to cut from the top or the bottom? Is the shock mount hole centered in the spring pocket?

 

[Independent]

I made a bushing that uses the shock hole to guide the hole saw. Basically you take the drill out of the hole saw arbor, insert the bushing, and drill it out from the bottom.

 

[-YumYum97s10-]

Sonoma*

 

[Wrkn prgs]

:stupid:

 

[ground_sniper]

Good luck!