S-10 Forum banner

1 - 3 of 3 Posts
I

·
Guest
Joined
·
0 Posts
Discussion Starter #1
I was looking under my truck trying to figure get a good visual on how I was going to install my parrell four link and my crossmember over my gas tank (the tank will be moved to allow for the four link) is about where I need to weld up the park of the link that connects to the frame. How hard is it to move the x member or would jasons allow for a lot more room. or any good ideas how to solve this problem
 

·
Registered
Joined
·
13,733 Posts
Jason's would solve your problem, because it mounts ontop of the frame. Tho you could just fabricate your own if you wanted.
 
I

·
Guest
Joined
·
0 Posts
Discussion Starter #3
I should be able to make one I have a welder and a plasma cutter so I think Im set
 
1 - 3 of 3 Posts
Top