[WTS-RCN-808]

Howzit gang. I hope i didnt miss a thread that already has the answer to my question, if so sorry:bash: Anyways I lowered my 98 2.2 xcab last weekend with a 3/4 Belltech kit(2"spindles,1"coils,3"leafs,1"blocks,&nitro shocks).From a stop up to about 10-12mph Im feeling a vibration from the center and rear area(i think ) I was thinking of putting in a aftermarket carrier bearing crossmember and replacing the bearing. Any suggestions? Am I on the right track?
Thanx for any help.:thumbup:

 

[low_huh?]

it sounds like you pinion angles is off.........check your drive shaft in the rear and make sure it is in line........if your drive shaft is on an angle up or down you will get vibration

 

[Twin-10s]

did you use angled blocks or 2 degree shims?
x cabs need them for any drop 3 inches or more in most cases.

 

[96S-10 4.3]

Belltech #4975 shims will fix it.

 

[jaydawg]

Sup bruddah.

I have the same vibration too. I have the 4"chassis tech angled blocks too.
Check out the thread to us 808 guys

here

K-den
Jay

 

[WTS-RCN-808]

Thanx for the info:thumbup: I didnt shim anything yet and my 1" blocks are not tapered. I'll get shims this weekend. Will a STS crossmember correct the angle or would I still need to add shims?

 

[Twin-10s]

from what i was told you still need the shims even with the cross member.