S-10 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,151 Posts
Discussion Starter · #1 ·
My brother, father, & I installed a set of Edelbrock Tes headers & y-pipe combo on my truck today. Definately a difference in power. The engine revs alot faster & smoother. I ran a 2.5" exhaust too. No cat & a Summit muffler. For $15 this muffler was well worth it. It has a very deep tone without being obnoxiously loud. I can't wait till I get it broken in. Maybe tomorrow I'll get to run it & post some new times.

Later,
Derrick
 

·
Registered
Joined
·
1,151 Posts
Discussion Starter · #5 ·
It took about 6 hours. Nothing was really hard about the install, just time consuming because of all the little stuff. The hardest part was the power steering bracket that bolts to the manfiold. The Edelbrock set came with long bolts & spacers, but it wsa a pain to take the bracket off. A couple tips I'll give is to take the front tires off and go in through the fender wells. Everything is right there in front of you. When ready to remove manifolds & install headers, do it from the bottom of the truck. The coolant sensor on the driver's side of the block has to be removed, but after it is taken out everything will slip right in & out with no trouble.
 
1 - 3 of 3 Posts
Top