[sprtn20's]

i just dropped my blazer using eibach springs up front (2.3) and 3 inch belltech blocks out back. the back is sittin lower than the front, is there a problem with me cutting .5 inch off of the blocks? is that safe?

 

[Twin-10s]

its no problem at all. i have done it many times.just remember you will need to drill the hole deeper after cutting it down.

 

[97sdime]

if its an angled block i wouldn't mess with it.. now if its just a regular flat block i don't see a problem

 

[DrPonziBrinkley]

if its an angled block i wouldn't mess with it.. now if its just a regular flat block i don't see a problem

I second that.

 

[Rhotpursuit]

if its an angled block i wouldn't mess with it.. now if its just a regular flat block i don't see a problem

can you elaborate on that a little...

 

[97sdime]

:thumbup:

 

[bg's]

I had mine done at a machine shop since they were angled. Took
off .5 using the true center as the reference point. I have cast iron
blocks. Came out nice for $20...

 

[Twin-10s]

it will not matter angled or not. angled blocks are angled on the pin side cutting the bottom will not affect anything. for that matter cutting either side is no big deal if you know what your doing. i have done it b4 its no big deal.

 

[lowhombre]

i just dropped my blazer using eibach springs up front (2.3) and 3 inch belltech blocks out back. the back is sittin lower than the front, is there a problem with me cutting .5 inch off of the blocks? is that safe?

ill sell you 2" blocks for 25 bills shipped:clap: