S-10 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1 (Edited)
Home made Intake

Hey 4 bangers:idea:
Well yall might not like this cause i got pretty bad comments
BUT i ran dryer hose from my throttle body to the left and down to under my truck. Its positioned over what i think is the front sway bar. I also clamped a K&N cone filter off the end. Its soo much better than all that piping to the throttle and the air silencer(I can tell a difference at higher rpms 4500 -5500). Any one else have any good ideas? Tell me! Im always willing to expirement with new ideas. :bash:

_________________________
96 Ext cab fleet side
flows,k&n,APC EURO tails, cleared out everything:idea:
 

·
Ahhhhhhhhh Satisfying!!!
Joined
·
5,174 Posts
For a more semi permanent solution run PVC piping like you did there, but connect a filter for it right behind the fog light hole.....

Caleb
 

·
Bolt-On Body Dropz
Joined
·
2,617 Posts
ya on my civic before i got a real cold air intake, we used to have pvc pipe running from the intake manifold
 
1 - 5 of 5 Posts
Top