S-10 Forum banner

head lights ... and lock cylinder

561 views 6 replies 3 participants last post by  comics22 
#1 ·
hey , i just replaced my ignition lock tumbler ... what a pain in the a$$ that was but i put it all back , checked my blinkers and went to work , on my way home i discoverd my high beams dont work .. what did i do wrong ?

thanks jason
 
#2 ·
yea .. and i mean by dont work , when i pull back on the lever it just pulls w/ no restance as if its not hooked up but the same lever still works the blinkers .. the up and down work .. not the front to back
 
#3 ·
what year of truck?

i know the1st gens the dimmer switch is kinda far down the steering column that is pushed by a somewhat long metal rod (gets pushed down when u pull back)

did you happen to find any extra rods hangin around or hear one slide down? its about half as thick as a pencil so its kinda big

i belive the 2nd gens are like this too but dont quote me on that
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top