S-10 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter #1 (Edited)
My Torker II lower manifold needs porting to the top piece. The top is the 2 chamber version. The right bank of ports look like they can be ported back far enough to actually have to cut into the wall separating the chambers in the upper manifold piece. Has anybody done the porting job and is there any advice? I've got the carbide burrs and I'm ready to go, but I don't want to blow it. :guitar:
 

·
Registered
Joined
·
79 Posts
Discussion Starter #2
Got an answer

I contacted Edelbrock technical support and they tell me to just round off the edges on the base intakes. Nothing else. :clap:
 
1 - 2 of 2 Posts
Top