S-10 Forum banner
1 - 1 of 1 Posts

222 Posts
Discussion Starter · #1 ·
I just installed my flamesd gauge faces. They look great and work great. Every guage reads accurately and moves proper. Thought that I would share a tip that I found. May sound obvious though.

Use a digital camera to take a picture of the position of the needles before removing them. Print out the picture and use that as a reference instead of a sketch as the instructions suggest.

Hope this helps. Made install easy. The whole thing took less than 15 minutes.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.