S-10 Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
2,193 Posts
Discussion Starter · #4 ·
by the way (whoring my own thread) slammeddime... how are the viair 380c compressors? do you know much about them? they are rated at 200 psi. however, i would just like to run 180 daily... i figure that i can sacrifice a little fill speed by getting these... and yet be able to run 180 daily and not go over max psi on the 450c and not reach max psi on the 380c. i may be retarded but hey thats what you are for... to edgamacate me!
 

· Registered
Joined
·
2,193 Posts
Discussion Starter · #10 ·
ok now how much are those tee fittings with the drilled and tapped gauge feed from irsd_mini. so if it is a 1/2 fitting... it has 3 1/2 openings... and a drilled and taped opening for 1/8 compression. is this right? i saw that someone had crosses that were 4 1/2 openings... i think...
 

· Registered
Joined
·
2,193 Posts
Discussion Starter · #14 ·
i know what you mean... but i have everything i need for 5/8 and 1/2 fittings from work and this tee from irsd_mini is the only thing i need so i will be willing to pay a little extra for 1/2 tee's instead of 3/8. i know it wont slow you down but i dont want to have more fittings than neccesary.
 

· Registered
Joined
·
2,193 Posts
Discussion Starter · #16 ·
fock it... if i get caught taking anymore someone might get mad... i was told to only take so many... it too everything i needed! the only last thing i need is 4 of these nifty tee's you guys keep talkin about. ill pm him right now.

slammed dime... thanks alot, you have been more help than i can ask for!

steve
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top