S-10 Forum banner

Fuel line advice

767 Views 1 Reply 2 Participants Last post by  bk2life
Hello. Ive got a 1990 s10 4.3l tbi I’m slowly working on and one of the feed lines attached to the back of the carb was severed, i think someone bent it when removing the carburetor, it runs down and the rubber end slides over the other fuel line that goes into the frame. Following so far? so anyway, I just plan on replacing that, well it seems that’s a lot harder to find than I thought. Can I use braided lines and if so, could someone send me a link to a full kit? I’m not 100% what the diameter should be.
See less See more
1 - 1 of 2 Posts
go to your local autozone and get high pressure fuel line, and good clamps. thats a quick fix. or
find someone local to braze the tear in the steel fuel line.
look on ebay for a replacement.
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.