S-10 Forum banner
1 - 1 of 1 Posts

4 Posts
Discussion Starter · #1 ·
I am having a hell of a time getting the the bearing assembly off the steering knuckle. Anyone have any tips?

I have never had one this bad before. I have currently attempted the following:

All night soak in penatrating oil, a hammer, a bigger hammer, and a little heat.

Of the three bolts that attach the bearing assembly to the knuckle, one was hard all the way out.

I can't really get a puller on it because the half shaft is loose. (Axle nut is off, of course)

4wd 2002 LS with the 4.3.

Any help would be greatly appreciated.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.