S-10 Forum banner

1 - 5 of 5 Posts

·
V6PLUS2
Joined
·
425 Posts
Discussion Starter #1
Hey, for christmas im getting a megashifter, or some type of ratchet floor shifter. I was wondering what all i need to get it installed. Also, could someone tell me where to get the parts that ill need to get it installed.
Joel
 

·
zippy
Joined
·
733 Posts
i had a light truck megashifter in my 91' and it pretty well came with everything except the wiring for the back-up lights and neutral saftey switch. should be pretty easy to install. my 92 came with one so i kinda lucked out there.
 

·
Dead Project Truck
Joined
·
649 Posts
B&M is really good about giving you everything you will need to install their shifter. Youll need to cut a hole in the floorboard for the new shifter cable to go thru to the trans. On mine I just ran jumper wires from the shifters neutral safety and reverse lights to the factory wiring. The worst part about the install is tightening the nuts from the bottom side of the truck and that reallys insnt too hard, just annoying with the transmission right in the way.
 
1 - 5 of 5 Posts
Top