S-10 Forum banner

Firewall harness

391 Views 5 Replies 4 Participants Last post by  JDs1991s15
Has anyone had any luck trying to push the harness through the hole on the passenger side under the heater box? I’m trying to get mine separated so I can thin out the harness for my swap. The rubber grommet around the harness doesn’t seem to want to move. Maybe there’s a trick to get it out?
1 - 1 of 6 Posts
They're just gooed in good. Scrape off as much as you can so you can see what you're doing. Won't swear to it, but I seem to remember a couple sheet metal crews holding it in place until the engine side is bolted on.
1 - 1 of 6 Posts