S-10 Forum banner
1 - 2 of 2 Posts

·
pwnt
Joined
·
643 Posts
Discussion Starter · #1 ·
I'm just building a cover for my box to hide, one of my amps, distribution blocks, etc, and rather than using a peuny 3" brush to try and spread resin over the matte, could I use a "sponge" type roller to roll the resin on and then use the short bristled brush to "jab" the resin into the matte to fully saturate it? I figured the roller would also help with removing bubbles.

any thoughts?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top