Driveshaft after lowering

362 Views 5 Replies 3 Participants Last post by mattckurtz, 5 mo ago

mattckurtz

Discussion Starter · 5 mo ago

Hello, and I thank you for your help in advance. I used a 3" Ground Force lowering kit(springs in front and blocks out back) to lower my daughters 98 std cab short bed. I reinstalled the driveshaft today(2.2l manual) and it was a very snug fit. Do I need to get the drive shaft shortened?

Save

1 - 1 of 6 Posts

Brawndo

· #5 · 5 mo ago

Axle Set Back Plates for V8 S10

Why You Might Need One. For those who are leary of driveshaft modification when installing a V-8 into the S-10 truck, the alternative is to relocate the rear axle rearward 1/2" by installing axle set-back plates. As crude as this may sound, the stock location of the rear axle normally places the...

jagsthatrun.com