S-10 Forum banner

Driveshaft after lowering

362 Views 5 Replies 3 Participants Last post by  mattckurtz
Hello, and I thank you for your help in advance. I used a 3" Ground Force lowering kit(springs in front and blocks out back) to lower my daughters 98 std cab short bed. I reinstalled the driveshaft today(2.2l manual) and it was a very snug fit. Do I need to get the drive shaft shortened?
1 - 3 of 6 Posts
Very snug, no wiggle room. What is wrong with the springs up front?
Thank you, I appreciate the information. I will get the driveshaft shortened and change up the front end.
  • Like
Reactions: 1
1 - 3 of 6 Posts