S-10 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
745 Posts
Discussion Starter · #1 ·
So while putting in my GM 8.625 axle in my s10, I didnt realize the actual snout on the axle was longer. In my frustration of trying to figure out why my driveshaft wouldnt go in, I took the damper off the pinion yoke. So do I actually need it? or will I be fine without it?

And if I do need it, can I just go get another yoke off a full size chevy with a 30 spline yoke with the damper? Or do I have to get it off a blazer like the axle came out of?

Just trying to get this figured out before I measure for my driveshaft and get it made next week.
 
1 - 1 of 1 Posts
Top