S-10 Forum banner

Do I have to change the springs to add drop spindles?

829 Views 6 Replies 6 Participants Last post by  SSandfish
I have a 95 RWD 4 dr Blazer that needs a front end rebuild. I am thinking of doing drop spindles since I am changing the upper and lower control arms out anyway. My question is, do I have to add different springs, or do I have to cut the front springs, or will the stock front springs still work? The vehicle only has 150,000 miles on it if that has any bearing on spring life, etc... I am only lowering the front. Going for stance. Adding a cowl induction hood soon as well (as soon as I find one cheap enough). If anyone can point me to a previous thread, or has instructions, or advise that is constructive and helpful, that would be welcomed.


1 - 1 of 7 Posts
2" Belltech spindles stock springs
17x8 w/245 45 17
Tire Wheel Car Land vehicle Automotive side marker light
See less See more
  • Like
Reactions: 1
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.