S-10 Forum banner

Daily s10

5716 Views 55 Replies 8 Participants Last post by  MyWorkInProgress
I am doing this over since I never actually did an upgrade thread on my s10 that replaced my 4 door blazer. I purchased this truck late November and it really needed A LOT hence the good deal. It is a stripper truck, no carpet, no power doors but it does have a 4.3, 4l60e exactly what I wanted.

The brakes were destroyed........
The Blazer was robbed of many parts for this s10 lol.
2" drop spindles
Slotted and drilled rotors
New Stainless brake lines

I did end up putting a factory shifter and console in it, cannot find the pics of that at this time I may just upload a pic later.

I also had some issues with the fuel sending unit the precious owner put some plastic JB Weld on the fittings so a new sending unit was ordered and I used a Quantum 255 pump, then I replaced the spider injection now she runs sweet and gets great fuel mileage.

As for now the s10 is on 2" drop spindles, and 2.5" blocks. 275-40-18s. The 8.8 is not quite ready to be installed but I will cover that soon.

I switched my front end to the Envoy, just a little bit of body prep and it will be ready for paint, thank goodness....

I know she looks a little rough but she will be tightened up soon.
I am adding power doors that I got from a real clean Jimmy, great price too! They stay off until everything is painted.

See less See more
  • Like
Reactions: 3
1 - 3 of 56 Posts
The piston shaft length is better for s10s with lowering springs whereas the Gabriel Ultras are very nice
Why do you people do this?
Copy and paste parts of other peoples post, trying to make it look like they aren’t scammers trying to get their post counts up. It’s the second thread they’ve done it in so far.
thank you very much
Also keep in mind you’re going to have to match your gearing front to back. The 8.8 can come with 3.73s, so if you have a GT4 RPO code front diff to match you’re golden, unlikely in your truck though, GU6 most likely.
1 - 3 of 56 Posts