S-10 Forum banner

Daily s10

5716 Views 55 Replies 8 Participants Last post by  MyWorkInProgress
I am doing this over since I never actually did an upgrade thread on my s10 that replaced my 4 door blazer. I purchased this truck late November and it really needed A LOT hence the good deal. It is a stripper truck, no carpet, no power doors but it does have a 4.3, 4l60e exactly what I wanted.

The brakes were destroyed........
The Blazer was robbed of many parts for this s10 lol.
2" drop spindles
Slotted and drilled rotors
New Stainless brake lines

I did end up putting a factory shifter and console in it, cannot find the pics of that at this time I may just upload a pic later.

I also had some issues with the fuel sending unit the precious owner put some plastic JB Weld on the fittings so a new sending unit was ordered and I used a Quantum 255 pump, then I replaced the spider injection now she runs sweet and gets great fuel mileage.

As for now the s10 is on 2" drop spindles, and 2.5" blocks. 275-40-18s. The 8.8 is not quite ready to be installed but I will cover that soon.

I switched my front end to the Envoy, just a little bit of body prep and it will be ready for paint, thank goodness....

I know she looks a little rough but she will be tightened up soon.
I am adding power doors that I got from a real clean Jimmy, great price too! They stay off until everything is painted.

See less See more
  • Like
Reactions: 3
1 - 1 of 56 Posts
Nice clean looking truck . Like where your going with it .
1 - 1 of 56 Posts