S-10 Forum banner

1 - 2 of 2 Posts

·
praise the lower'd
Joined
·
1,024 Posts
Discussion Starter #1
i just got my eibach loweing springs and was wondering if there are any tips/tricks to putting them in. Im putting spindles on too. i think i know what im supose to do but any help would be appreciated


thanks scott
 

·
The Primered Panther
Joined
·
313 Posts
I've done it way more times than i've wanted to but it's not that hard. you just separate the lower ball joint from the spindle, pull the old one out, put the rubber cushions on the new springs, but the tricky part is to make sure the spring is in the little groove it's supposed to be in on top and bottom. You should be able to see where the spring is supposed to sit on the lower A-arm.
 
1 - 2 of 2 Posts
Top