S-10 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I've heard of it being done before and these are a tad wider than a bbc. Anyone have any info on what mods were needed regarding swap clearance mods? I have several 345 - 400 hp stockers with TH400s gathering dust. Thanks.
 

·
Wyotech = October
Joined
·
1,356 Posts
Yeah big blocks fit with modification, so Im sure those will fit with even more modification.. You might have to run skinnies in the front and open fenders..
 

·
2006 PBM GTO
Joined
·
492 Posts
I have seen a couple of these motors in full sized trucks, and they had to notch the passanger frame rail for the exhaust manifold to clear. I know that my Blazer frame is just a little wider than the full size, so you might not have to do that. It would definitely be coll though.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top