S-10 Forum banner

1 - 3 of 3 Posts

·
HittinSwitchs4The Bit*h's
Joined
·
330 Posts
Discussion Starter #1
I'm getting ready to notch my dime. I work at a ship yard so instead of buying pre made notch's or paying osme to make them, why not make them myself?!?! Well I was wondering if anyone could give me the measurements on a 8 or 10 inch notch. Also which notch should I go with an 8 or 10 inch notch? Thanks
 

·
Registered
Joined
·
203 Posts
You can make them out of 2x3 tubing, just mitre the ends and you can make it as tall as you like. Or you can make it out of 3/16's plate.
 
1 - 3 of 3 Posts
Top