S-10 Forum banner
1 - 3 of 3 Posts

·
Aye! Sea Turtles
Joined
·
380 Posts
Discussion Starter · #1 ·
I want to get my truck as low as I possibly can without the use of bags (mainly because I'm too poor right now) and wanted to lower my 2nd gen like I did my last truck.

I was looking into bump stops, and I found these: Bump Stop Kits

Not too sure what the factory measurements are on the OEM bump stops but I do know it's really big, alot bigger than anything listed on the above link.

Which do you think would be the best to go with?
 

·
Afterhours Admin
Joined
·
28,712 Posts
From that pic, id go with maybe the first one on the left. The right one wont be stiff enough and the middle one is too short, the control arm will hit metal on metal in the back before the bumpstop hits the frame in the front.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top