S-10 Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
611 Posts
Discussion Starter · #1 ·
I am wanting to do a cut out enclosure and cannot find any pics to look at to find out what I would like to do. Ya'll please post picks of blow-thru enclosures and doesn't matter if it is st. cab or ext. cab....Post links about blow-thru's too...
 

·
Damn right I'm a maniac.
Joined
·
9,571 Posts
C'mon man, at least try. There was a post on the exact same topic six posts down from this one...
 

·
Registered
Joined
·
611 Posts
Discussion Starter · #4 ·
Come on man, I have looked for four days for a blowthrough, blow thru, and blow-through. I am looking for specific pictures for a st. cab s10 with a box similar to what I want... So quit bashing me, OK!
 

·
Registered
Joined
·
1,160 Posts
try doing a search, I just posted this about a week ago and yesterday.

1. take out the air saw, cut the bed first, then the cab.
2. place accordian rubber on bed and cab, seam at the bottom. make it so the metal channel lines up, then make a piece to overlap. silicon this piece down to the bottom one.
3. build box.
4. build a port that fits agains the box and is about 1" smaller than the cut out all around.
5. secure port to box and slide forward until the front of the port is just inside the back wall or flush with it.
6. finish off the back wall. EX. piece of 1/4" hardboard with carpet on it and cut it out around the port.


I have posted these sites before, but here it is. this is a shop that I used to work for.

http://bz-2.com/f150.html

http://bz-2.com/73ford.html

http://bz-2.com/denali.html
 
1 - 7 of 7 Posts
Top