S-10 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter #1
I just had the blazer droped. 2" spindles/1" springs Front. 3" blocks for the rear, for a 3 & 3 drop. It was leaning (driver side) befor the drop, and is still leaning about 5/8 inch. I'm thinking rear springs because of the age of vehicle. I'm thinking simple fix is to cut the pass side block to even out the drop. I would have a machine mill the block. Anyone run in to this problem ? Looking for cure.
 
1 - 3 of 3 Posts
Top