S-10 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,733 Posts
remove taillight, use a 24 with a small piece of 2x2 screwed on the edge so it looks like an L. put that in the tail light hole and pry it around while you push the dented in sheetmetal out. You can get creative and grind the wood to a more rounded piece of wood and have a nice buck to slightly hammer on the outside of the bed against the wood.
You can work that dent almost 100% back to perfect..youll need to go at it from the light hole and from underneath the bed. But that is thin sheetmetal right there, and very easily workable.
 
1 - 2 of 2 Posts
Top