[Yowakawaka]

Can someone tell me the clearances for the rod and main bearings using plastigage? Also, the ring clearances when you measure the clearances in the cylinders? In using feeler gauges.
Any other advice/info is helpful.

Thanks in advance,
Yowakawaka

 

[Rhotpursuit]

Can someone tell me the clearances for the rod and main bearings using plastigage? Also, the ring clearances when you measure the clearances in the cylinders? In using feeler gauges.
Any other advice/info is helpful.

Thanks in advance,
Yowakawaka

You gave no info on the year or type of engine. Since you already have a build thread, you'd be better off asking there.

 

[Yowakawaka]

I figured bearing and ring clearances were standard.

I reposted this post in the engine Build

 

[pmpueo]

I figured bearing and ring clearances were standard.

I reposted this post in the engine Build

buy a genuine GM shop service manual. has all the specs in it. lots of them on ebay. get the paper manual, not CD.

 

[Yowakawaka]

@pmpueo I have a manual for an 85 s15 Jimmy.

Check out my thread. I’m could use the help.